Stamina 45-0900A, Owner'S Manual

OPERATIONAL INSTRUCTIONS

WALKING RESISTANCE

The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline 

angle. This treadmill has two adjustment positions.

Lowest Resistance

Remove (unscrew) the 

BUMPER STANDS(17)

from the bottom of the treadmill and store them 

in the end of the treadmill.

Highest Resistance

The 

BUMPER STANDS(17)

 are attached to 

the bottom of the treadmill.

NOTE:

The safety and integrity designed into the 

inMotion® T900 Treadmill

 can only be maintained when the 

inMotion® T900 Treadmill

  is  regularly  examined  for  damage  and  wear.  Special  attention  should  be 

given to the following:

MAINTENANCE

12

1.  Since this is a new machine, you may need some time to get used to walking on the treadmill and to 

break it in.

2.  If the walking resistance is still too high, check the 

BELT TENSION

. Refer to page 11 for instructions to 

adjust belt tension.

3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe 

the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board 

under the belt

.

1.  Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.

2. Verify that the 

LOCKING KNOB(5)

 is present and functioning properly. Repair or replace parts as 

necessary.

3.  Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.  

Tighten loose nuts and bolts.

4.  Verify that the 

CAUTION LABEL(52)

 is in place and easy to read. Call Stamina Products immediately 

at 1-800-375-7520 for a replacement 

CAUTION LABEL(52)

 if it is missing or damaged.

5.  It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

6.  Worn or damaged components shall be replaced immediately or the 

inMotion® T900 Treadmill 

removed from service until repair is made.

7.  Only Stamina Products supplied components shall be used to maintain/repair the 

inMotion® T900 

Treadmill.

8.  Keep your 

inMotion® T900 Treadmill

 clean by wiping it off with an absorbent cloth after use.

9.  If the 

WALKING BELT(14)

 does not move easily, lubricate the 

BOARD(15)

 under the 

WALKING 

BELT(14)

 with silicone lubricant.

Meijer.com