1. To store the
inLINE® Back Stretch Bench,
simply keep it in a clean dry place.
2. Adjust the
HEIGHT ADJUSTMENT BEAM(44)
and
MAIN FRAME(1)
to the shortest position. The
inLINE® Back Stretch Bench
is approximately 56 inches long x 18.5 inches wide x 14 inches tall.
These dimensions will vary. Please measure your
inLINE® Back Stretch Bench
if exact dimensions
are needed.
3. To move the
inLINE® Back Stretch Bench,
lift by the
CUSHION(12)
on one end and the
HEIGHT
ADJUSTMENT BEAM(44)
at the other end. Use caution as the
SWING ARMS(6)
may move and
cause a pinching hazard.
The safety and integrity designed into the
inLINE® Back Stretch Bench
can only be maintained when
the
inLINE® Back Stretch Bench
is regularly examined for damage and wear. Special attention should
be given to the following:
1. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
2. Verify that the
CAUTION LABEL(40)
is in place and easy to read. Call Stamina Products immediately
at
1-800-375-7520
for a replacement
CAUTION LABEL(40)
if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the
inLINE® Back Stretch Bench
removed from service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the
inLINE® Back
Stretch Bench.
6. Keep your
inLINE® Back Stretch Bench
clean by wiping it off with an absorbent cloth after use.
STORAGE
MAINTENANCE
9
STRETCH SYSTEM
The
inLINE® Back Stretch Bench
stretches the back with
its one way rack and pinion engineering. Lie on the
inLINE®
Back Stretch Bench
with the
ARMPIT PADS(8)
under your
armpits, and the
FOAM PADS(24)
holding your ankles. Pull the
LEVER(13)
back and forth as many times as needed until you
feel a gentle stretch. Stop pulling at the desired position and stay
at the stretched position for a few minutes. Push the
LEVER(13)
firmly toward your feet to release the stretch.
Push the Lever toward
your feet to release.
Pull the Lever back and forth
as many times as needed to
reach the proper stretch.
OPERATIONAL INSTRUCTIONS
