Stamina 55-1532, Owner'S Manual

ASSEMBLY INSTRUCTIONS

8

STEP 5

Attach the 

FOOTREST(8)

 onto the 

HEIGHT ADJUSTMENT BEAM(6)

 with the 

ADJUSTMENT KNOB(9).

NOTE:

STEP 6

Insert the 

PAD TUBE(10)

 through the hole on the 

HEIGHT ADJUSTMENT BEAM(6)

 and secure with 

HEX

BOLT(M6x1x47mm)(40),

NYLOCK NUT(M6x1)(42),

 and 

WASHERS(M6)(45).

  Place a 

HEEL HOLDER

BRACKET(11)

 onto a 

HEEL HOLDER(12),

 then slide them onto 

PAD TUBE(10) 

together.  Slide another

set of 

HEEL HOLDER BRACKET(11)

 and 

HEEL HOLDER(12)

 onto the other end of the 

PAD TUBE(10).

STEP 7

Attach the 

ADJUSTABLE INSTEP FRAME(7)

 to the 

HEIGHT ADJUSTMENT BEAM(6)

 by pulling the 

SMALL

SPRING PIN(15)

 and sliding the 

ADJUSTABLE INSTEP FRAME(7)

 completely into the 

HEIGHT

ADJUSTMENT BEAM(6).  

Place a 

WASHER(M6)(45)

 onto the 

HEX BOLT(M6x1x47mm)(40),

 then insert

the bolt the halfway through the square tube on the 

HEIGHT ADJUSTMENT BEAM(6),

 slide the bolt through

the ring at the bottom of the 

SPRING(13),

 slide the bolt through the square tube and secure with 

NYLOCK

NUT(M6x1)(42)

 and 

WASHER(M6)(45).  

Press the 

SQUARE PLUG(35)

 into the 

HEIGHT ADJUSTMENT

BEAM(6).  

Slide the 

FOAM PADS(31)

 onto both sides of the 

ADJUSTABLE INSTEP FRAME(7).

The four adjustment holes in the 

FOOTREST(8)

 allow the 

FOOTREST(8)

 to be attached in four

different positions. Start with one of the center positions and adjust if necessary. Use the higher
position holes if users are taller than average. Use the lower position holes if users are shorter than
average.