12
USING THE ELECTRONIC METER
BUTTONS:
POWER ON :
Pedal movement or push any BUTTON.
Automatic shut off after 4 minutes of inactivity.
POWER OFF :
Press to stop lower display functions and go to
SET mode. SET must be displayed to preset TIME,
REV, LOAD, and TEMPO values. Press
START/
STOP
button again to remove SET from display
and start lower display functions.
Press to select lower display functions. Lower
display functions include SCAN, DISTANCE,
TIME, REV, LOAD, TEMPO, and CALORIES.
Press to preset values for TIME, REV, LOAD, and
TEMPO. Press
START/STOP
button to go to SET
mode, select function with
MODE
button, and set
value with
SET
button. Hold the button down for
fast advance.
Press to reset TIME, REV, or TEMPO to zero.
Computer must be in SET mode to RESET any
function.
START/STOP :
MODE :
SET :
RESET :
Displays speed in miles per hour on upper display.
Lower display automatically scans DISTANCE, TIME, REV, TEMPO, LOAD, and CALORIES with a
change every four seconds.
Displays distance up to 999.9 miles in increments of 0.1 miles. Counts down from preset value.
Displays time in minutes and seconds up to 99 minutes, 59 seconds. Counts down from preset value.
Displays total crank revolutions up to 9999 revolutions. If REV is preset, it counts down in increments
of one revolution.
The tempo is an audible pulse that can set to beep at time intervals from 0.125 seconds to 9.875
seconds by pressing the
SET
button.
NOTE:
To stop the tempo function, simply set the tempo value to zero or press
RESET
button.
The LOAD level can be set from 1 to 5. The setting will affect the CALORIE display. Check the setting
on the
TENSION KNOB(29)
and refer to the information below to set the LOAD level on the Electronic
Meter.
FUNCTIONS:
SPEED:
SCAN:
REV:
TIME:
DISTANCE:
LOAD:
TEMPO:
The meter will shut off automatically after 4 minutes of inactivity. All function values will be kept. Push
the
RESET
button to reset the functions to zero.
If the display is illegible or only partial segments appear, remove batteries and wait for 15 seconds
then reinstall batteries.
NOTE:
1.
2.
RPM:
CALORIE:
Displays estimated Calories up to 9999 Kcal.
NOTE:
The CALORIE readout is an estimate for an average user. It should be used only as a
comparison between workouts on this unit.
A bar graph across the bottom displays crank RPM (revolutions per minute) in hundreds.
NOTE:
This reading will normally be very low on the
7000 EMR Premium Magnetic Bike.
Load Level 1
Tension setting: 1 & 2
Load Level 2
Tension setting: 3 & 4
Load Level 3
Tension setting: 5 & 6
Load Level 4
Tension setting: 7
Load Level 5
Tension setting: 8
