ASSEMBLY INSTRUCTIONS
8
CABLE END
SPRING HOOK
BRACKET
METAL FITTING
STEP 5:
Pull the ends of the
TENSION CABLE(28)
and
SENSOR WIRE(32)
out of the
MAIN
FRAME(1).
Slide the
UPRIGHT SLEEVE(37)
onto the
UPRIGHT(4).
Insert the female end of the
CONNECTION WIRE(31)
into the
UPRIGHT(4)
and connect it to the
SENSOR WIRE(32).
Slide the
TENSION CABLE(28)
into the bottom end of the
UPRIGHT(4). NOTE:
Be careful not to damage the
SENSOR WIRE(32).
Insert the
UPRIGHT(4)
onto the
MAIN FRAME(1).
Make sure that the
TENSION
CABLE(28)
is accessible through the square hole in the
UPRIGHT(4).
Secure the
UPRIGHT(4)
to the
MAIN FRAME(1)
with
BUTTON HEAD BOLTS(M8 x 15mm)(50)
and
ARC WASHERS(M8)(62).
Slide the
UPRIGHT SLEEVE(37)
down to cover the bolts on the
UPRIGHT(4).
NOTE:
The square hole in the
UPRIGHT(4)
is on the side facing the user as shown.
STEP 6:
Pull the end of the
TENSION CABLE(28)
through the square hole in the
UPRIGHT(4).
Set
the
TENSION KNOB(29)
at position
"1".
Connect the
CABLE END
of the
TENSION KNOB(29)
into
the
SPRING HOOK
on the end of the
TENSION CABLE(28).
Pull on the
TENSION KNOB(29)
firmly
so that enough cable is available to insert the cable through the slot in the
BRACKET.
Then insert the
METAL FITTING
on the
TENSION KNOB(29)
into the hole at the end of the slot in the
BRACKET.
STEP 7:
Install the
TENSION KNOB(29)
into the square hole on the
UPRIGHT(4)
and secure with
SCREW(M5 x 45mm)(67)
and
ARC WASHER(M5)(68).
