ASSEMBLY INSTRUCTIONS
8
STEP 3
NOTE:
The
RIGHT PEDAL(10)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(10)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(70)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(70)
has left hand threads and is tightened by turning
counterclockwise.
Thread the
RIGHT PEDAL(10)
into the
RIGHT CRANK(8)
as shown. Tighten the pedal securely. Select
the
RIGHT PEDAL STRAP(11)
which has
R
marked on it. Snap the three hole end to the inside edge of
the
RIGHT PEDAL(10).
Insert the other end of the strap through the slot and snap the strap to the hook
on the outside edge of the
RIGHT PEDAL(10).
Select adjustment holes which allow your foot to be easily
removed from the pedals.
Use the same procedure to attach the
LEFT PEDAL(70)
to the
LEFT CRANK(9)
and to attach the
LEFT
PEDAL STRAP(71)
to the
LEFT PEDAL(70).
STEP 4:
Refer to the Bottom View below. Attach the
SEAT(23)
to the
SEAT SLIDER(6)
by inserting the
connector of the
SEAT SLIDER(6)
into the
SEAT(23)
and lock in position by tightening the
NUT(M8x1.25).
Pull the
ADJUSTMENT KNOB(44),
then insert the
SEAT POST(5)
into the
MAIN FRAME(1)
and secure
with the
ADJUSTMENT KNOB(44).
NOTE:
The pin of the
ADJUSTMENT KNOB(44)
must be inserted into one of the adjustment holes in the
SEAT POST(5)
and the
ADJUSTMENT KNOB(44)
must be screwed in tight to ensure that the
SEAT POST(5)
will fit securely in the
MAIN FRAME(1).
Bottom View
Nut
With the
SEAT(23)
attached to the
SEAT SLIDER(6),
and the
SEAT POST(5)
attached securely to the
MAIN
FRAME(1),
adjust the
SEAT(23)
to a level position. Loosen the
NUTS(M8x1.25)
under the
SEAT(23),
and
raise or lower the front of the
SEAT(23)
until the top of the
SEAT(23)
is parallel to the floor. Make sure that
the seat points straight forward and securely re-tighten the
NUTS(M8x1.25).