18
OPERATIONAL INSTRUCTIONS
OPERATION DESCRIPTIONS
A. DATE / CLOCK SET UP
(Only can be done right after the batteries are installed.)
The Meter operates with two AAA batteries, the batteries are not included. The date and clock must be
reset anytime batteries are replaced.
Install two AAA batteries into the Meter per instructions on page 21. The Meter will then display all items on
the screen and a “beep” will sound for two seconds. The Date/Clock setting display will be blinking as shown
in illustration 1. Press the
SET
button to set the date and clock. You can use the
RESET
button to go back
to the preset value of each setting item. Press
MODE
button to confirm the setting and move to next setting.
1.
2.
B. INPUT PERSONAL DATA
(You may exit the setting by pressing the MODE button, and input your data later.)
Now, the display will look as illustration 2, shown the blinking Male symbol. Press the
SET
button to switch
to Female symbol. Press
MODE
button to confirm your gender and move to next item. The Meter will go
through the input items as follows and allow you to input your personal data.
Height (3 to 8 feet)
Weight (20 to 440 lbs)
Age (10 to 99 years old)
Use
SET
button to enter the values of your
HEIGHT, WEIGHT,
and
AGE.
Press
MODE
button to confirm
the setting and move to next item for setting.
NOTE:
You can input your personal data at any time. Press the
MODE
button and hold it down for five
seconds to reset all functions to zero and skip to Personal Data setting mode.
Month
Day
Year
3.
4.
C. BODY FAT MEASUREMENT
(You may exit the body fat measurement by pressing the RESET button.)
Every time right after you input your personal data, the Meter will skip to body fat measurement mode
automatically. The display will look as illustration 3. You have option to press the
RESET
button to quit the
body fat measurement function. Or, press the
MODE
button and hold the pulse sensors on the Handlebar
with both hands to do the body fat measurement. A few seconds later, the Meter will display the information
for FAT%, BMI, and BODY TYPE cyclic for 75 seconds, refer to illustration 4. Press any button, except
BODYFAT
button, to exit the display.
NOTE:
1.
Once you have correct personal data in the meter. You can simply press the
BODYFAT
button
and hold the pulse sensors on the Handlebar with both hands to do the body fat measurement
at any time.
2. If you do not hold properly or remove your hands from the Pulse Sensors. If no signal is available, an
error code
E1
will displayed. P
ress the
BODYFAT
button and do the body fat measurement again.
