Stamina ATS Air Rower 1406, Owner'S Manual

ASSEMBLY INSTRUCTIONS

8

NOTE:

  There are some packing parts attached on the 

STAMINA® ATS Air Rower 1406.

 Please follow 

the steps below to remove them before any assembly. These parts are only for packing, do not 

dispose of the packing materials until assembly is completed.

STEP 1

Remove the 

CARDBOARD ROLLER

 from the front of the 

MAIN FRAME(1)

 by removing the 

SCREWS

and 

WASHERS.

STEP 2

A 

BUCKLE

 has been attached to the 

STRAP(24)

 to prevent the 

STRAP(24)

 from returning into the main 

body of the 

STAMINA® ATS Air Rower 1406

 during shipping. Remove the 

BUCKLE

 by following these 

steps:

1.  Refer to detail view 1. Pull the 

STRAP(24)

 away from the main body about 8 inches. Use one hand to 

hold the 

STRAP(24)

 at position 

A

 while using the other hand to pull the 

STRAP(24)

 loop on the top of 

the 

BUCKLE

 to the position as shown in detail view 2.

2. Refer to detail view 2. Continue to hold the 

STRAP(24)

 at position 

A.

 Pull the 

STRAP(24)

 from 

position 

B

 until the 

STRAP(24)

 is completely removed from the 

BUCKLE.

 Make sure the 

STRAP(24) 

isn't twisted and let it return into the main body of the 

STAMINA® ATS Air Rower 1406.

 The 

STRAP(24)

 will hold the 

HANDLEBAR(16)

 taut against the 

MAIN FRAME(1).

1.

2.

Cardboard Roller

A

B

Buckle

Buckle

Buckle

Screws

Washers

A

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove 

all packing materials from your area and place them back into the box. Do not dispose of the packing 

materials until assembly is completed. Read each step carefully before beginning. If you are missing 

a part, please go to staminaproducts.com under the Customer Care section and order the part 

needed,  e-mail  us  at  customer.care@staminaproducts.com,  or  call  us  toll  free  at  1-800-375-7520 

(in the U.S.). Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central 

Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.

Some product parts are fit tested at the factory to ensure proper fit and alignment. Marks in 

the paint may be noticeable, but are not an indication of damage.