9
ASSEMBLY INSTRUCTIONS
L
STEP 12:
Refer to the inset drawing. Insert the
SHAFT SLEEVE(66)
into the
SUPPORT ARM(64).
Attach the
SUPPORT ARM(64)
at right side to
RIGHT PIVOTING ARM(46)
with
BUTTON HEAD BOLT
(M8x1.25x90mm)(109)
and
NYLOCK NUT(M8x1.25)(114).
Insert the
SHAFT SLEEVE(66)
into the
LINKAGE(67).
Attach
LINKAGE(67)
at right side to
TELESCOPING BAR(56)
in the
RIGHT PIVOTING
ARM(46)
with
BUTTON HEAD BOLT(M8x1.25x90mm)(109)
and
NYLOCK NUT(M8x1.25)(114).
Press a
NUT CAP(122)
onto each
NYLOCK NUT(M8x1.25)(114).
Repeat on the left side.
R
Do not cut off the
tie until STEP 12.
Install the right
PEDAL RAIL ASSEMBLY
by attaching the
PEDAL RAIL(59)
to the
RIGHT RAIL
CONNECTOR(85)
with
BUTTON HEAD BOLT(M10x1.25x85mm)(110), WASHER(M10)(118),
and
NYLOCK
NUT(M10x1.25)(116).
Repeat on the left side.
NOTE:
The
RAIL CONNECTORS(84, 85)
must face toward the back as shown in the illustration above.
STEP 10
NOTE:
An
"L"
decal identifies the
LEFT PEDAL SLIDER(71)
and an
"R"
decal identifies the
RIGHT
PEDAL SLIDER(72)
.
The
RIGHT PEDAL SLIDER(72)
is attached to the right
PEDAL RAIL ASSEMBLY
. Attach the right
PEDAL
RAIL ASSEMBLY
to the right side of the elliptical unit. Attach the
LEFT PEDAL SLIDER(71)
and
PEDAL
RAIL ASSEMBLY
to the left side of the elliptical unit in the same manner.
STEP 11:
Press the
RAIL CAPS(63)
into the
PEDAL RAILS(59)
and secure with
ROUND HEAD SCREWS
(M5x20mm)(95).
Do not cut off the
tie until STEP 12.
