11
ASSEMBLY INSTRUCTIONS
STEP 11
NOTE:
The
RIGHT PEDAL(41)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(41)
has
right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(39)
has
L
stamped on
the end of the pedal shaft. The
LEFT PEDAL(39)
has left hand threads and is tightened by turning
counterclockwise.
Thread the
RIGHT PEDAL(41)
into the
RIGHT CRANK(36)
as shown. Tighten the pedal securely. Select
the
RIGHT PEDAL STRAP(42)
which has
R
marked on it. Snap the two hole end to the inside edge of the
RIGHT PEDAL(41).
Insert the other end of the strap through the slot and snap the strap to the hook on the
outside edge of the
RIGHT PEDAL(41).
Select adjustment holes which allow your foot to be easily removed
from the pedals.
Use the same procedure to attach the
LEFT PEDAL(39)
to the
LEFT CRANK(35)
and snap the
LEFT
PEDAL STRAP(40)
to the
LEFT PEDAL(39).
STEP 12
Slide the
UPRIGHT SLEEVE(32)
over the
UPRIGHT(3).
Connect the
CONNECTION WIRE(26)
to the
CONTROL WIRE(25).
Insert the
UPRIGHT(3)
onto the
FRONT FRAME(1)
and secure with
FLAT HEAD
BOLTS(M8x1.25x15mm)(79).
Slide the
UPRIGHT SLEEVE(32)
down to cover the bolt heads.
