ASSEMBLY & OPERATIONAL INSTRUCTIONS
STEP 1:
STEP 2:
NOTE:
2
Insert the STABILIZERS(2) into both ends of the MAIN FRAME(1) and secure
with BUTTON HEAD BOLTS(M6x1x12mm)(16) and ARC WASHERS(M6)(17).
DO NOT TIGHTEN COMPLETELY.
Adjust the STAND CAPS(3), set the
Upper & Lower Body Cycle
on the floor
and tighten the bolts.
Bolt the T KNOB(14) into the hub on the MAIN FRAME(1).
There are two adjustment holes on each side of the PEDAL STRAPS(12). Select
the adjustment holes which allow your feet to be easily removed from the
PEDALS(11).
The surface of the crank housing may become
hot during use, so allow it to cool before
moving.
Read the cautions posted on the
Upper & Lower Body Cycle
.
CAUTION:
Caution Decal
(both sides)
