Stamina InMotion II 45-1002C, Owner'S Manual

11

OPERATIONAL INSTRUCTIONS

NOTE:

The  safety  and  integrity  designed  into  the 

InMotion® II Treadmill

  can  only  be  maintained  when  the 

InMotion® II Treadmill

 is regularly examined for damage and wear. Special attention should be given to 

the following:

MAINTENANCE

1.  Since this is a new machine, you may need some time to get used to walking on the treadmill and to 

break it in.

2.  If the walking resistance is too high, check the 

BELT TENSION

. Refer to page 10 for instructions to 

adjust belt tension.

3. The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe 

the board under the belt with a clean, dry cloth then spray or spread silicone lubricant on the board 

under the belt.

WALKING RESISTANCE

The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline 

angle. This treadmill has two adjustment positions.

Lowest Resistance

Remove (unscrew) the 

BUMPER STANDS(22)

from the bottom of the treadmill and store them 

in the end of the treadmill.

Highest Resistance

The 

BUMPER STANDS(22)

 are attached to 

the bottom of the treadmill.

1.  Clean the exposed surfaces of the 

WALKING BELT(17)

 and the 

BOARD(18)

 with an absorbent cloth.

2.  It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.

3.  Verify that the 

SPRING PIN(6)

 is present and functioning properly. Verify that the 

BALL KNOB(8)

 is 

securely attached to the 

SPRING PIN(6).

 Repair or replace parts as necessary.

4.  Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten 

loose nuts and bolts.

5.  Verify that the 

CAUTION LABEL

(54)

 is in place and easy to read. Call Stamina Products immediately at                                  

1-800-375-7520 for a replacement 

CAUTION LABEL

(54)

 if it is missing or damaged.

6.  Worn or damaged components shall be replaced immediately or the 

InMotion® II Treadmill

 removed 

from service until repair is made.

7.  Only Stamina Products supplied components shall be used to maintain/repair the 

InMotion® II Treadmill.  

8.  Keep your 

InMotion® II Treadmill

 clean by wiping with an absorbent cloth after use.

9.  If the 

WALKING BELT(17)

 does not move easily, lubricate the 

BOARD(18)

 under the 

WALKING BELT(17)

with Silicone Lubricant.