ASSEMBLY INSTRUCTIONS
10
IMPORTANT
STUDY THE FOLLOWING ILLUSTRATION AND READ ALL OF STEP 8 “a” through
“f” BEFORE ATTACHING PEDALS AND CONNECTING LINKAGES.
STEP 8
NOTE:
The
RIGHT PEDAL(32)
has
R
marked on the bottom side of the pedal. The
LEFT PEDAL(31)
has
L
marked on the bottom side of the pedal. Both
PEDALS(31, 32)
have
RIGHTHAND THREADS.
Tighten both
PEDALS(31, 32)
by turning clockwise.
a. Slide the two
PEDAL WASHERS(1/2”)(33)
onto both
PEDAL SHAFTS
of
PEDALS(31, 32).
b. Insert
PEDAL SHAFTS
of
PEDALS(31, 32)
through the
LINKAGES(9).
c. Slide
SPACERS(34)
onto
PEDAL SHAFTS.
WARNING:
SPACERS(34)
must be between
LINKAGES(9)
and
CRANK(10)
so that there will be enough
clearance between
LINKAGES(9)
and
CRANK(10).
d. Thread
PEDAL SHAFTS
of
PEDALS(31, 32)
into
CRANK(10)
and securely tighten.
e. Hold
PEDAL SHAFTS
and thread
THIN NUTS(1/2”-20)(35)
onto
PEDAL SHAFTS.
f. Tighten
PEDAL SHAFTS
and
THIN NUTS(1/2”-20)(35)
until
THIN NUTS(1/2”-20)(35)
are tight.
STEP 9
Install two AA batteries into the
METER(47),
the batteries are not included. See page 12 for detailed battery
installation instructions. Plug the
SPEED PICKUP WIRE(23)
into the connecting wire on the
METER(47).
Slide the
METER(47)
onto the plate on the
MAIN FRAME(1).
NOTE:
Be careful not to damage the wires when attaching the
METER(47).
