"OPEN". From now on the user has 4 seconds to open the door by turning the knob
and pulling it towards themselves.
b) To set the user code, press the red cipher button located on the inside of the
unit door and immediately select the "START" key. Then enter the combination.
The display will show "IN" and a sequence of selected digits.
c) To set the management code, select the "START" button on the lock panel and
enter the combination of digits. Then press the red coding button. The display will
show "IN".
d) If the combination is entered incorrectly, the LCD display will show "ERROR" and
the red indicator light will illuminate.
CAUTION!
It is possible to set two independent combinations, user and
management.
The combination should be between 3 and 8 digits long!
CAUTION!
It is possible to enter a combination without displaying it on the
LCD screen. To do so, select and press the "START" button twice, then enter the
combination!
CAUTION!
Entering an incorrect sequence of digits 3 times results in the
temporary locking of the lock for 3 minutes (you cannot enter the combination
again)!
After waiting the specified time you will be able to make another
attempt to enter the combination.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive cleaning agents for cleaning the surfaces.
b)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
c)
Do not spray the unit with a stream of water or immerse it in water.
d)
Make sure that no water enters through the ventilation openings in the casing.
e)
Use a soft cloth for cleaning.
f)
Do not leave the batteries in the unit when it will not be used for a long time.
INSTRUCTIONS FOR SAFE DISPOSAL OF RECHARGEABLE BATTERIES AND
BATTERIES.
The units are equipped with AA 1.5V batteries.
Disassemble used batteries from the unit following the same procedure as for
their installation.
Hand the batteries over to the entity responsible for disposal of these materials.
