DE
21
EN
REGULAR CLEANING
Generalities
• Never clean the device with a pressurized water-jet, industrial cleaners, and brushes
or any other type of cleaning utensil that could damage the surface of the appliance.
• Before cleaning you must remove the electricity supply plug isolating the appliance
from the main power circuit.
REGULAR CONTROL OF THE DEVICE
Control regularly that the device doesn´t present any damage. If it should be the case,
please contact your customer service to solve the problem.
What to do in case of problem?
Please contact your customer service and prepare following information:
•
Invoice number and serial number (the latest is to be found on the technical pla-
te on the device).
•
If relevant, a picture of the damaged, broken or defective part.
•
It will be easier for your customer service clerk to determinate the source of
the problem if you make a detailed and precise description of the matter. Avoid
formulations like “the device doesn´t heat”, which may mean that it doesn´t heat
enough or even not at all. Though, those two possibilities have a different causati-
on!
The more detailed your information, the quicker the customer service will be able to
answer your problem rapidly and efficiently!
CAUTION: Never open the device without the authorization of your customer ser-
vice. This can lead to a loss of warranty!
REPLACEMENT OF THE SOLDERING IRON TIP AND SOLDERING
IRON HEATING CORE ELEMENT
1. nut for mounting the soldering iron tip housing
2. soldering iron tip housing
3. soldering iron tip
4. plastic nut for mounting the heater and the board wires
5. spring
6. heater
7. wires board
8. handle
Before heater replacement make sure that the soldering iron is completely cold.
1. SOLDERING IRON TIP REPLACEMENT: remove the nut for mounting the solde-
ring iron tip housing and take off the housing. Replace the tip with the new one,
place the housing and fix all with the plastic nut.
2. HEATER REPLACEMENT: remove the nut for mounting the soldering iron tip
housing and take off the housing along with the tip. Remove the nut for fixing the
heater (4) and gently remove the heater (6) along with the board with wires (7).
Replace the whole remembering the wires connection order.
1
2
3
4
5
6
7
8
EN
20
