11UNO User
’s Manual
Revision 6
7
Standa Ltd. All rights reserved
Fig. 1-2 11UNO Connectors
1.4 Connector Description
1-
EXTERNAL POWER SUPPLY INPUT JACK.
Input voltage required: 9 VDC/100 mA. The external power supply does not charge the
batteries; it allows the use of the monitor without batteries, with dead batteries or simply to
avoid discharging the batteries inside the monitor.
CAUTION
Permanent damage to the optical meter may occur if an external
power supply other than provided by Standa is used. Please call
Standa or your local distributor if extra power supplies are
needed.
2-
PROBE INPUT JACK.
The 11UNO uses a DB-15 female connector to mate with the detector heads (probes).
The 11UNO works with all Standa power detectors currently sold. It automatically
recognizes every power detector head, which ensures accurate auto-calibration. More
importantly, it can take advantage of our
Personal
wavelength correction
™. It reads the
memory in the
Smart Interface
connector to provide a wavelength correction that is based
on spectral data measured from that specific detector.
2
Getting Started
This section contains important information concerning the installation and operation of the 11UNO.
The 11UNO is delivered ready to use. Just install the 4 AA batteries, insert a detector head in the
Probe Input Jack (#2 in Figure 1-2) and press the
I/O
key.
2.1 Power measurement procedure
1- Install the power detector on its optical stand.
2- First, slide the connector latch to the right to unlock the connector.
