N
Dispenser Sub Type
(The Factory Default Setting for Dispenser Sub Type is 1)
To make changes to the Dispenser Sub Type feature, follow the step by step procedure outlined below.
Note: The five-position switch and red selection button are located on the dispenser control board. For
machines with multiple dispenser, these settings must be set on each dispenser control board for this
feature to be activated.
IMPORTANT: Please note the original switch setting before starting this procedure. You will need to
return the switches to this original setting to assure proper operation after making any changes. As a
convenience, you can enter these original settings in the diagram to the right by simply marking an “X”
for UP (ON) or DOWN (OFF) on each switch.
1.
Activate the Dispenser Sub Type programming mode by setting:
Switch 1 – ON; Switch – OFF; Switch 3 – OFF; Switch 4 – ON;
Switch 5 – ON
2.
Press the red selection button one time.
3.
Advance to the Dispenser Sub Type selection by setting: Switch 1 – ON; Switch 2 – OFF;
Switch 3 – OFF; Switch 4 – OFF; Switch 5 – OFF
4.
Press the red selection button eleven times.
5.
Now set the switches to the desired setting Choice numbers 1 through 3 as per the chart below.
Once you have made your selection, press the red selection button one time. Example: Set
switches to match choice 3 if you want the Dispenser Sub Type set to “Fujitsu F53/56”.
6.
End the programming sequence by resetting the switch to their original settings, and then press
the red selection button one time to put the machine back into service.
DISPENSER SUB TYPE CHOICES
CHOICE
SETTING
SWITCH POSITIONS
SW2
SW3
SW4
SW5
1
COIN/GD BILL DISPENSER
OFF
OFF
OFF
ON
2
FUJITSU F50 BILL DISPENSER
OFF
OFF
ON
OFF
3*
FUJITSU F53 BILL DISPENSER
OFF
OFF
ON
ON
4
MDB RECYCLER
OFF
ON
OFF
OFF
5
GLORY MINIMECH
OFF
ON
OFF
ON
6
GLORY MULTIMECH
OFF
ON
ON
OFF
7*
MDB TUBE CHANGER
OFF
ON
ON
ON
*
If choice 3 or 7 is selected, please refer to page “T” to set the dispenser values. Both top and bottom
cassettes will need a value programmed into the dispenser board before the machine will operate
correctly.
12 345
