X
Dispenser Value
(The Factory Default Setting for Dispenser Value is “$00.00”).
To make a change to the Dispenser Value, follow the step by step procedure outlined below.
Note: The five-position switch and red selection button are located on the dispenser control board. For
machines with multiple dispensers, these settings must be set on each dispenser control board for the
feature to be activated. This is the value for one item.
1.
Activate the Dispenser Value programming mode by setting:
Switch 1–ON; Switch 2-OFF; Switch 3-ON; Switch 4-OFF; Switch 5-ON
2.
Press the red selection button one time. This advances you to the “Tens” digit of the dollar amount.
3.
Now set switches to desired setting from the Choice numbers 1 through 10 below.
4.
Press the red selection button one time. This advances you to the “Ones” digit of the dollar amount.
5.
Now set switches to desired setting from the Choice numbers 1 through 10 below.
6.
Press the red selection button one time. This advances you to the “Tens” digit of the cents amount.
7.
Now set switches to desired setting from the Choice numbers 1 through 10 below.
8.
Press the red selection button one time. This advances you to the “Ones” digit of the cents amount.
(“Ones” digit can only be set to either 0 or 5.)
9.
Now set switches to desired setting from the Choice numbers 1 through 10 below.
Multi-Denomination Bill/Tube Dispensers
– repeat steps 2 through 9 for each additional cassette or
tube up to four cassettes or tubes total.
For coin changers only program each denomination that will be dispensed .5,.10,.25,1.00. If all tubes
are the same value, you only need to program one denomination.
For bill dispensers if the cassette has the same denomination bill as another they both have to be
programmed separately. The first cassette programmed will be the top one, the second is the next one
down (if looking at the dispenser) and so on. When the last cassette is programmed proceed to the next
step. If your machine was purchased without the optional EF+ Module, you must use the “Forced
Dispense Feature” (page J) to set the bill dispensed settings or the Make Best Change feature will
determine the bills dispensed automatically.
Example – In a BX machine, it would be necessary to set a force dispense to five (5) if you want (5)
one dollar bills dispensed for (1) five-dollar bill accepted. The force dispense amount will be dispensed
from the top cassette.
10.
Press the red selection button one time.
11.
End the programming sequence by resetting the switches to the OFF (down) position, and then
press the red selection button one time to put the machine back into service.
