SPEAKER INSTALLATION
To obtain the best possible sound, flush-mount speakers should be mounted
in a bulkhead or panel to provide adequate isolation between the front and
rear of the speaker. A baffle area of approximately 2ft x 2ft is desirable when
bulkhead mounting. If mounting on a shelf or panel, the speaker can be
enclosed in a box, preferably with a volume area of 1 cubic foot.
Speakers which are fully enclosed in their own speaker boxes and incorporate
a gimbal mounting bracket can be mounted in any convenient location.
Although these speakers have water resistant cones, they should be mounted
in a sheltered position away from direct spray.
See Figure 5 for speaker connections.
WARNING
●
Do not allow the speaker leads (even the common lead) to come into
contact with grounded metal on the vessel or the negative (-) supply. If any
speaker lead is connected to chassis ground, the amplifier in the MST65
will be damaged.
●
Do not allow the speaker leads to "short" together as this will also cause
damage to the MST65 amplifier. Damage caused by the above may not be
covered by warranty.
Figure 5. Speaker Installation
MST65 Owner’s Manual Page 7
1
-
+
2812
