CPN700i and CPN1010i Multimedia Chart Plotters
Page 107
System Alarm Report
Displays the report of the four alarms: Arrival Alarm, Anchor Alarm, XTE Alarm and Depth
Alarm. When one of these alarms exists, a check mark is printed on the relative box. Once
the alarm condition is no longer present, the relative check mark is removed.
2.14
ADVANCED SETTINGS
The Advanced Setup menu allows customization of many GPS functions and NMEA
interfacing.
1. Press the
key, tap on
Setup Menu
.
2. Tap on
ADVANCED
. While in this menu you will see many selections which are
described in the next sections.
2.14.1 NAVIGATE MENU
The Navigate menu allows customization of the Coordinate System (Loran TDs), Chart
Datum, Chart Orientation Resolution (angle the vessel has to change before the chart is
redrawn) and Static Navigation. See the following table:
Coordinate System
: Selections are:
a.
TD
: Time Difference, based on Loran
b.
UTM
: Universal Transverse Mercator Grid
c.
ddd mm.mmm
: Degrees Minutes and Thousandths of Minutes
d.
ddd mm.mm
: Degrees Minutes and Hundredths of Minutes
e.
ddd mm.ss
: Degrees Minutes and Seconds
Chart Datum
: Allows selection of Chart Datums. The default Datum is WGS 1984 as C-MAP
BY
J
EPPESEN
cartography has been compiled using the WGS84 Datum. A datum is a mathematical
model of the earth which approximates the shape of the earth, and enables calculations
such as position and area to be carried out in a consistent and accurate manner.
Chart Orientation Res.
: Sets the angle the vessel has to change before the chart is redrawn. The default setting
is 30°. Example: if the vessel is heading 000T at a speed of 25 Knots, the display will
redraw:
a.In Home Mode the CPN Series Chart Plotter centers the location of the vessel in the
center of the display while it is displayed in the center or on the bottom of the screen
(depending on the setting). To keep the vessel in the center of the display the CPN
Series Chart Plotter will occasionally redraw.
b.If the vessel changes course greater than 330T or more than 30T the chart will be
redrawn.
Static Navigation
: Sets up a threshold for the speed. When the speed received from the GPS is under the
selected value, the CPN Series Chart Plotter displays zero.
Loran TD
The Loran TDs selection allows the CPN Series Chart Plotter to be set up so the user can
enter in LORAN TDs directly into the CPN Series Chart Plotter. After the TDs have been
entered, and the user changes to ddd mm.sss (Degrees Minutes and Seconds) the TDs will
be converted to Lat/Lon coordinates. To use the TD Coordinate System the user must set
up the Chain and Pair information of the TDs. If you do not know this information, refer to
paper charts that show the Chain and Pair information. See the following table:
Summary of Contents for CPN1010i
