Page 4 Owner’s Manual MST70
Refitting
1. Make sure the face panel is the right way up as it cannot be attached
upside down.
2. Fit the right-hand end of the face panel into the tabs inside the right-hand
end of the unit.
3. Gently press the left-hand end of the face panel into place until it clicks.
Only light pressure is required.
INSTALLATION
Mounting
The MST70 is designed to be mounted in several different ways so that it can
be installed in the most convenient position.
Although the MST70 is water
resistant when the front cover is closed, care should be taken to locate
it where it will not be subjected to spray or rain.
The diagrams below show
the various methods of bracket mounting available.
Overhead Mount
Upright or Overhead Mounting
1. Attach the two gimbal knobs and self-adhesive rubber washers to the
MST70 and slide the unit into the mounting bracket. Ensure the rubber
washers are between the bracket and the radio. Tighten the knobs firmly.
2. Temporarily position the MST70 in the desired location, tilting the radio
in the bracket to ensure you are able to get the required adjustments for
viewing angle etc.
3. Roughly mark the location of the bracket edges, then seperate the radio
from the bracket and reposition the bracket to mark the mounting hole
positions. A range of mounting holes are provided to suit most installations.
Upright Mount