Page 71
GX2000/GX2100
11.9
POSITION REPORT
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
for the
GX2000/GX2100
to send the position.
NOTE
To transmit a Position Report Call, a GPS must be connected to the
radio and the
GX2000 / GX2100
Individual directory must be programmed
with stations you wish to send your position to. To setup this directory
refer to section “
11.5.1 Setting up the Individual / Position Call Direc-
tory
.”
11.9.1 Setting up a Position Report Ringer
The
GX2000/GX2100
has the capability to turn off the Position Report ringer.
1. Press and hold down the [
CALL
(
MENU
)] key
until “
Setup Menu
” appears.
2. Rotate the
CHANNEL
knob to select “
DSC
SETUP
” menu.
3. Press the [
SELECT
] soft key, then select “
DSC
BEEP
” with the
CHANNEL
knob.
4. Press the [
SELECT
] soft key, then select “
POS
Report
” with the
CHANNEL
knob.
5. Press the [
ENT
] soft key, then select “
Off
” with
the
CHANNEL
knob.
6. Press the [
ENT
] soft key to store the selected set-
ting.
7. Press the [
QUIT
] soft key several times to return to
radio operation.
To re-enable the ringer tone, repeat the above procedure, rotating the
CHAN-
NEL
knob to select “
On
” in step “5” above.
11.9.2 Transmitting a DSC Position Report Call
Pre-Programmed Calling
1. Press the [
CALL
(
MENU
)] key. The “
DSC
Menu
” will appear.
2. Rotate the
CHANNEL
knob to select “
POS RE-
PORT
”. (To cancel, press the [
QUIT
] soft key.)
3. Press the [
SELECT
] soft key.
4. Rotate the
CHANNEL
knob to select the name in
Summary of Contents for GX2000
Page 113: ...Page 113 GX2000 GX2100 MEMO ...
Page 133: ...Page 133 GX2000 GX2100 MEMO ...
Page 134: ...GX2000 GX2100 Page 134 MEMO ...
