02
1.3 Safety Instructions
• Operate the pump only under the specified pump.
• Any tension, contraction and strain on the piping system should never transfer to the pump.
• Electric wiring of the engine and auxiliary components should definitely comply with the local rules
and be performed by the authorized personnel.
• Never perform any work on the pump before the pump set is stopped completely.
• Any work on the pump should always be performed by at least two workers.
• Clothing of the personnel to work on the pump should always be suitable for the works they
will
perform and/or the personnel should use necessary safety equipment.
• Never perform any work on the pump when it is hot.
• Never touch the hot pump and pipes by naked hand. The user personnel should take necessary
warning precautions (e.g. warning signs, barricades, etc.).
• Always be careful when working on the pumps delivering hazardous liquids (e.g. acid or hazardous
fluids).
• When the pump and pipes connected to the pump are under pressure, do not perform any work on
the pump definitely.
• Once the work on the pump is over, put in place all safety shields previously removed.
• Never operate the pump in reverse direction.
• Never insert pour hands and fingers into any hole or openings of the pump.
• Do not trace on the pump and/or pipes connected to the pump.
1.3.1 CE signs and approvals
It is a legal requirement that machinery and equipment put into service within certain regions of the
world shall conform with the applicable CE Marking Directives covering Machinery and, where
applicable, Low Voltage Equipment, Electromagnetic Compatibility (EMC), Pressure Equipment
Directive (PED) and Equipment for Potentially Explosive Atmospheres (ATEX).
Where applicable, the Directives and any additional Approvals, cover important safety aspects
relating to machinery and equipment and the satisfactory provision of technical documents and
safety instructions. Where applicable this document incorporates information relevant to these
Directives and Approvals. To confirm the Approvals applying and if the product is CE marked, check
the serial number plate markings and the Certification, see the last page of this document.
Always observe the following instructions to prevent any physical and/or property
damages.
Always disconnect power connection with the engine before you perform any work on the
pump and make sure that no connection is made accidentally.
