6
machine.
Residues inside staple channel.
Take off stapling head, remove both screws
of front plate (18), take off front plate.
Clean staple channel and reassemble the
stapling head.
Driver blade (16) is scratched or bent.
Put in a new driver blade.
Button “START” (6) is being pushed
without paper inside the machine.
Remove jammed staples from the anvils
and fire only with paper being inserted.
Staples give a weak bind because staple
legs are too short.
Use staples 26/8S with 8mm leg length for
thick paper sets. See chapter 2.
Paper cannot be inserted properly
Selector (8) is in position for “CORNER
You can only insert paper for 5cm (2”)
when side or corner stapling. This is
normal. Set selector (8) into position
“BOOKLET’ if you wish to produce
booklets.
Paper is not being folded and ejected
Knob (3) at the machine’s left side is
pulled out, disengaging the folding knife.
Pull the knob, turn it by 90
°
, push it
towards the machine.
Internal problem.
Contact your dealer.
Booklet is stapled correctly but incorrectly ejected
Reduce stickiness of fold rollers because of
dirt.
Clean fold rollers.
Too many sheets have been inserted.
Do not insert more than 15 sheets. See
chapter 9.
Booklets are being stapled or folded incorrectly
The side guides (10, 11) or the back stop
(14) are fixed improperly and move
around.
Fix the locking screws of the side guides
and back stop properly.
The side guides (10, 11) are too far apart
from each other, allowing unparallel
insertion of paper.
Shift side guides more closely together.
See chapter 3.1.
The side guides (10, 11) are adjusted to
tightly, causing larger paper formats to curl
during folding which leads to incorrect
stapling.
Shift side guides farther apart. See chapter
3.1.
Incorrect adjustment of backstop (14).
Adjust backstop more precisely, so that the
machine folds in the center of the sheets.
Paper is not squared up correctly.
Square up paper correctly before firing.
