Security Pole
Assembly Instructions:
FIGURE 1
NOTE:
The Security Pole is designed to be used with
ceiling heights that range from 7 to 10 foot ceilings.
Determine where you plan to use this product and
the height of the ceiling before continuing the assembly
process.
1.
Take all parts out of the box and lay them on a flat
surface as shown in Figure 1.
2.
If you have a 7 foot ceiling, do not use Extension Tube
(ITEM-2). Attach the Upper Frame (ITEM-1) directly to
ITEM-3 by aligning the holes in ITEM-1 and ITEM-3 and
inserting the Clevis Pin (ITEM-6) through the holes.
After the Clevis Pin is inserted, place the Cotter Pin
(ITEM-7) through the hole of the Clevis Pin and bend the
end of the Cotter Pin to secure the Clevis Pin as shown
in Figure 2.
3.
If you have an 8 to 10 foot ceiling, attach the Upper
Frame (ITEM-1) to the Extension Tube (ITEM-2) by
aligning the holes and inserting the Clevis Pin and Cotter
Pin as shown in Figure 2.
4.
The Extension Tube (ITEM-2) has 2 sets of holes
marked “A” and “B” in Figure 1. The set of holes marked
“A” are for an 8 foot ceiling. The set of holes marked “B”
are for a 9 or 10 foot ceiling.
FIGURE 2
5.
Attach the Extension Tube (ITEM-2) to (ITEM-3) by
aligning the appropriate ceiling height set of holes,
marked “A” or “B” of (ITEM-2) with the mating holes in
the Upper Tube (ITEM-3) and inserting the Clevis Pin
and Cotter Pin as previously done in Step 2.
6.
Attach ITEM-5 to ITEM-4, as shown in Figure 1, by
aligning the slots in ITEM-4 with the internal pin in ITEM-5
so the slots straddle the internal pin to prevent rotation
between ITEM-5 and ITEM-4, and as shown in Figure 3.
FIGURE 3
7.
Insert the threaded portion of ITEM-3 into ITEM-4 and
place the Safety Pole in the desired location with ITEM-5
on the floor and ITEM-1 on the ceiling.
NOTE:
Make sure the Plastic Washer (ITEM-11) is placed
between the Adjustment Nut (ITEM-8) and the Washer
(ITEM-9) as shown in Figure 1 before inserting ITEM-3 into
ITEM-4.
8.
Secure the Safety Pole between the floor and the ceiling,
the Adjustment Nut (ITEM-8) must be tightened in a
clockwise direction with the included wrench (Item not
shown). Tighten the lower Adjustment Nut until the Safety
Pole is secured between the floor and the ceiling.
NOTES:
If the Safety Pole does not appear to be securely fastened
between the floor and ceiling, loosen the Adjustment Nut
(ITEM-8) and make sure the length of the Safety Pole is
perpendicular to the floor and ceiling before tightening the
Adjustment Nut (ITEM-8) again as previously done in Step
8. If additional securing is needed, two Wood Screws
(ITEM-10) can be installed into the ceiling joists as shown
in Figure 4 and two screws can be installed through the
Base Foot (ITEM-5) into the floor.
Slight movement of the pivoting handle is normal and safe.
This movement allows the locking pin to easily lock into 8
user friendly positions. Pull the pin and rotate the curved
handle. Release the handle and continue to rotate the
curved handle until the spring loaded pin locks the handle
into the desired position.
FIGURE 4
