２１
your left hand while holding tension on the abrasive strip with your right
hand and guiding the material onto the drum. Use this technique to warp
the abrasive strip edge to edge radially around the drum. Make sure you
do not overlap the material as you wrap the abrasive (Figure 16). The
material should be flush to slightly gapped, but not overlapped, during the
wrap.
Figure 16
4. When you have completely wrapped the drum, keep tension on the strip
and insert the remaining tapered end of the strip into the slot in the drum.
Using your right hand, raise the tensioner clip completely to open the jaws.
Insert the tapered end of the abrasive strip (Figure 17). The tensioner clip
will secure and tension the abrasive strip during use and will
hold
tension
in the event the strip stretches during use. If the abrasive strip is not tightly
captured, the tensioner clip was not raised sufficiently to open the jaws
properly before inserting the abrasive strip.
Figure 17
Summary of Contents for MM3126
Page 31: ...３０ DIAGRAM 1 ...
Page 32: ...３１ DIAGRAM 2 ...
