４
source.
22.
STAY ALERT.
Never operate a power tool when tired or while under the influence of
drugs, alcohol, or medication.
23.
MAKE SURE A TOOL IS CONNECTED
only to the voltage marked on the
nameplate.
24.
NEVER USE A TOOL
if its cover or any bolts are missing. If the cover or bolts have
been removed, replace them prior to use. Maintain all parts in good working order.
25.
NEVER START A TOOL
when its rotating component is in contact with the work
piece.
26.
SAVE THESE INSTRUCTIONS.
Refer to them frequently and use to instruct other
users. If you loan someone this tool, also loan them these instructions.
WARNING:
The operation of any power tool can result in foreign objects
being thrown into your eyes, which can result in severe eye damage. Before
commencing power tool operation, always wear safety goggles or safety
glasses with side shields and a full face shield when needed. We
recommend Wide Vision Safety Mask for use over eyeglasses or standard
safety glasses with side shields.
ADDITIONAL SAFETY RULES FOR WIDE DRUM SANDERS
1.
DURING NORMAL OPERATIONS,
there is a tendency for the tool to tip over, side, or
walk on the supporting surface. Always secure tool to workbench or workstand.
2.
NEVER MAKE A SANDING OPERATION
with the sanding drum dust cover or drive
guard removed
or opened
.
3.
NEVER MAKE A SANDING PASS
deeper than 0.8mm.
4.
DO NOT SAND MATERIAL
shorter than 76mm or narrower than 19mm.
5.
MAINTAIN THE PROPER RELATIONSHIP
between the infeed and outfeed surfaces
and the sander drum path.
6.
SUPPORT THE WORK PIECE ADEQUATELY
at all times during operation; maintain
control of the work at all times.
7.
DO NOT BACK THE WORK
toward the infeed table.
8.
DO NOT ATTEMPT TO PERFORM
an abnormal or little used operation without the
use of sturdy and adequate jigs, fixtures, stops, and a thorough understanding of the
operation being performed.
9.
BEFORE STARTING,
re-check to make certain adjustments are correct and all locks
and screws are tight.
10.
ALWAYS STOP THE MOTOR
and disconnect the power source before making any
adjustments or changing
abrasive
strips.
11.
STOP THE MACHINE
and re-check the motor/drum mounting bolts and feed rollers
for tightness after about 50 hours of
operation
. (See Figure8.)
Summary of Contents for MM3126
Page 31: ...３０ DIAGRAM 1 ...
Page 32: ...３１ DIAGRAM 2 ...
