5
Fitting Procedure
– 3/16” NeoBolt Nose Equipment
When plac
ing 3/16” NeoBolt, a spacer is required to reduce the stroke of the tool. Spacer part number
71256-02011
. To fit spacer, follow
procedure below:
1.
Remove adjusting nut
8
2.
Unscrew Nyloc nut
9
3.
Unscrew adjusting stop
10
4.
Fit 3/16” stroke modification adaptor to adjusting nut
8
5.
Screw adjusting stop
10
into adjusting nut
8
fully ensuring spacer is retained in between the two items.
6.
Screw adjusting nut
8
to spring housing
3
.
7.
Minimum and maximum stroke now 5mm
– 24mm respectively.
Fitting Procedure
– 1/4” NeoBolt Nose Equipment
The spacer
71256-02011
as mentioned in section
“Fitting Procedure – 3/16” NeoBolt Nose Equipment” must be removed prior to placing 1/4”
NeoBolt. Refer to the procedure in this section to remove it.
Minimum and maximum stroke is 10mm and 29mm respectively when the spacer is removed
Maintenance/Dismantling Instructions
THE AIR LINE MUST BE DISCCONNECTED BEFORE ANY DISMANTLING IS ATTEMPTED
1.
Unscrew the Adjusting Nut
8
from the Spring Housing
3
by hand.
2.
Unscrew the Spring Housing fully
3
using a 25mm A/F spanner. Remove the Spring
6
, Washer
5
and Hydraulic Piston
4
from the
rear of the tool.
3.
Refer to tool manual
07900-00930 GB
for further disassembly and maintenance.
Re-assemble in the reverse order.
For Safety and Full Servicing and Maintenance instructions, refer to the nG3 Genesis® tool Manual
(
07900-00930 GB
)
.
Item numbers in
bold
refer to the parts list on page 2 in this flyer.
