OPERATION PERIOD
Note:
When setting the operation period, the
programmer automatically sets a stop time which is
equal to the operation period added to the current
time. If you do not want the cooker to start
immediately, you will have to adjust the
STOP
time
accordingly.
1.
Press operation period button (second button
from the left), display shows “0.00” and
the cooking pot symbol is displayed steadily.
2.
Press plus button until the desired operation
period is displayed.
3.
Releasing the button starts the run down of
time.
4.
The operation period having elapsed, the
acoustic signal sounds with four beeps, pause,
four beeps etc.. The cooking pot symbol
disappears, letters “AUTO” flash until the
manual button is pressed. The cooking pot
symbol is illuminated steadily.
STOP
(Time at which you want cooker to switch off)
1.
Press operation stop button (third button from
left), display shows “0.00” and the cooking pot
symbol is displayed.
2.
Press plus button until the desired operation
STOP is displayed (Time at which you want
oven to switch off).
3.
Releasing the buttons start run down of time,
time - of - day reappears. Letters “Auto” and
the cooking pot symbol is illuminated steadily.
Operation Period starts at once.
4.
The operation period having elapsed, the
acoustic signal sounds with four beeps, pause,
four beeps etc.. The cooking pot symbol
disappears, letters “AUTO” flash until the
manual button is pressed. Thus switching over
to manual mode. The cooking pot symbol is
illuminated steadily.
MANUAL MODE
When programming operation period or operation
stop, the timer automatically transfers into automatic
mode, being displayed by the letters “AUTO”
illuminated. The set programs being completed,
letters “AUTO” illuminated. The set programs being
completed, letters “AUTO” flash and the time can be
switched over to manual mode by pressing the
manual button. The cooking pot symbol is
illuminated steadily.
CORRECTING OR CLEARING PROGRAMS
Set programs can be corrected at any time by
pressing the respective button and either the plus or
minus button depending on whether the program is
to be cut short or prolonged.
Clearing is done by setting the program to “0.00”.
Clearing operation period automatically causes
clearing of operation stop and vice-versa. When
operation period or operation stop are programmed
Time-Of-Day cannot be corrected. The setting of
nonsensical programs is impossible (e.g. operation
period is programmed and operation stop is set too
early).
NOTE:
In the event of a short term power failure the
clock display will disappear and then turn when the
power is reinstated. If the power supply is
interrupted for a lengthy period of time the clock
display will be lost.
OPERATING THE APPLIANCE
For the appliance to operate both the oven control
knob and the timer must be set correctly.
The oven control knob setting corresponds to a
temperature. The control setting and their
corresponding temperatures are shown on the
control panel to the right of the control knob. These
temperatures are a guideline to the average
temperature in the top oven.
Either time clock can be used to switch
automatically as outlined above. The mechanical
timer also has “continuous on” and continuous off”
mode on the digital time so the appliance must be
switched off using the oven control knob.
The indicator light on the control panel is illuminated
when the solenoid valve is open. It will take
approximately 8 seconds after the cooker is turned
on before the solenoid valve is opened.
OVENS
THE MAIN OVEN
This oven is your simmering oven, your baking oven
and your roasting oven. It is a generous size of 390
x 310 x 406 mm (15
1/4
x 12
1/4
x 16 inches) - big
5
