8
ENGLISH
(Original instructions)
u
Plug the charger (12) into an appropriate outlet before
inserting battery pack (6).
u
The green charging light (12a) will blink continuously
indicating that the charging process has started.
u
The completion of charge will be indicated by the green
charging light (12a) remaining ON continuously. The
battery pack (6) is fully charged and may be removed and
used at this time or left in the charger (12).
u
Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
Charger LED Modes
Charging:
Green LED Intermittent
Fully Charged:
Green LED Solid
Hot/Cold Pack Delay:
Green LED Intermittent
Red LED Solid
Note:
The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate a faulty battery pack by
refusing to light.
Note:
This could also mean a problem with a charger. If the
charger indicates a problem, take the charger and battery
pack to be tested at an authorized service centre.
Leaving the battery in the charger
The charger and battery pack can be left connected with the
LED glowing indefinitely. The charger will keep the battery
pack fresh and fully charged.
Hot/Cold Pack Delay
When the charger detects a battery that is too hot or too
cold, it automatically starts a Hot/Cold Pack Delay, the green
LED (12a) will flash intermittently, while the red LED (12b)
will remain on continuously, suspending charging until the
battery has reached an appropriate temperature. The charger
then automatically switches to the pack charging mode. This
feature ensures maximum battery life.
Battery state of charge indicator (Fig. B)
The battery includes a state of charge indicator to quickly
determine the extent of battery life as shown in figure B. By
pressing the state of charge button (6a) you can easily view
the charge remaining in the battery as illustrated in figure B.
Installing and Removing the Battery Pack from
the tool
Warning!
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
To install battery pack (Fig. C)
u
Insert battery pack firmly into tool until an audible click is
heard as shown in figure C. Ensure battery pack is fully
seated and fully latched into position.
To remove battery pack (Fig. D)
u
Depress the battery release button (7) as shown in
figure D and pull battery pack out of tool.
Attaching hook and loop sanding discs (Fig. E)
For best results, use STANLEY FATMAX accessories.
u
To attach the sanding sheet (9) , carefully center the sheet
over the sanding pad (5) ensuring the holes in the disc
align with the holes in the pad and press the sheet firmly
in place.
u
The hook and loop fastening system sanding sheet can be
easily removed by simply pulling it off. It can be reused as
desired.
Sanding sheet tips (Fig. F)
u
Detach the two additional diamond-shaped tips (10) from
the sanding sheet (9).
Note:
The diamond-shaped tip can be reversed and replaced
when worn.
u
When the front part of the tip is worn, detach it from the
sheet, reverse it and press it onto the diamond-shaped
pad tip (11) again.
u
When the whole tip is worn, remove it from the sanding
base and fit a new tip.
Note:
For optimal dust collection, ensure the correct type of
sanding paper is used.
Replacing Diamond Shaped Pad Tip (Fig. G)
When the sanding base tip (11) is worn, it can be replaced.
Spare parts are available from your dealer.
u
Remove the screw (13) .
u
Replace the worn part.
u
Fit and tighten the screw.
