Stanley FATMAX V20 LITHIUM ION SBW920, Manual

7

ENGLISH

(Original instructions)

Batteries

u

  Never attempt to open for any reason.

u

  Do not expose the battery to water.

u

  Do not store in locations where the temperature may 

exceed 40 °C.

u

  Charge only at ambient temperatures between 10 °C and 

40 °C.

u

  Charge only using the charger provided with the tool.

u

  When disposing of batteries, follow the instructions given 

in the section "Protecting the environment".

Chargers

u

  Use your STANLEY FATMAX charger only to charge 

the battery in the tool with which it was supplied. Other 

batteries could burst, causing personal injury and damage.

u

  Never attempt to charge non-rechargeable batteries.

u

  Have defective cords replaced immediately.

u

  Do not expose the charger to water.

u

  Do not open the charger.

u

  Do not probe the charger.

The charger is intended for indoor use only.

Read the instruction manual before use.

Do not attempt to charge damaged batteries.

lectrical safety

Your charger is double insulated; therefore no 

earth wire is required. Always check that the 

mains voltage corresponds to the voltage on 

the rating plate. Never attempt to replace the 

charger unit with a regular mains plug.

● If the supply cord is damaged, it must be replaced by the 

manufacturer or an authorised Stanley FatMax Service 

Centre in order to avoid a hazard.

Warning! Never attempt to replace the charger unit with a 

regular mains plug.

Features

This appliance includes some or all of the following features.

1. Battery pack

  2. Battery release button

  3. Variable speed trigger

  4. Forward/reverse control button

  5. Speed selector

  6. Worklight

  7   Anvil

Assembly

Warning! Before assembly, remove the battery from the tool.

Charging the battery (Fig. A)

The battery needs to be charged before first use and 

whenever it fails to produce sufficient power on jobs that were 

easily done before. The battery may become warm while 

charging; this is normal and does not indicate a problem.

Warning! Do not charge the battery at ambient temperatures 

below 10 °C or above 40 °C. Recommended charging 

temperature: approx. 24 °C.

Note: The charger will not charge a battery if the cell 

temperature is below approximately 10 °C or above 40 °C.

The battery should be left in the charger and the 

charger will begin to charge automatically when the cell 

temperature warms up or cools down.

Note: To ensure maximum performance and life of lithium-ion 

battery packs, charge the battery pack fully before first use.

u

  Plug the charger (8) into an appropriate outlet before 

inserting battery pack (1).

u

  The green charging light (8a) will blink continuously 

indicating that the charging process has started.

u

  The completion of charge will be indicated by the green 

charging light (8a) remaining ON continuously. The battery 

pack (1) is fully charged and may be removed and used at 

this time or left in the charger (8).

u

  Charge discharged batteries within 1 week. Battery life will 

be greatly diminished if stored in a discharged state.

Charger LED Modes

Charging:

Green LED  Intermittent

Fully Charged:

Green LED  Solid

Hot/Cold Pack Delay:

Green LED  Intermittent

Red LED  Solid

Note: The compatible charger(s) will not charge a faulty 

battery pack. The charger will indicate a faulty battery pack by 

refusing to light.

Note: This could also mean a problem with a charger. If the 

charger indicates a problem, take the charger and battery 

pack to be tested at an authorized service centre.