1
1. Health and Safety
Consumer Protection
As a responsible manufacturer, we take care to make sure
that our products are designed and constructed to meet the
required safety standards when properly installed and used.
It is essential that the base or hearth on which the cooker sits
should be level and capable of supporting the total weight of
one or both units.
The front plinth cover is removable and must not be
obstructed by flooring or tiles. If necessary the cooker must
be raised by the thickness of the tiles to ensure the plinth can
be removed.
n
Children less than 8 years of age shall be kept away
unless continuously supervised. Cleaning and
user maintenance MUST not be made by children
without supervision.
n
CHILDREN SHOULD BE KEPT AWAY FROM THE
APPLIANCE AS SOME SURFACES CAN BECOME HOT
TO THE TOUCH.
n
WARNING: ACCESSIBLE PARTS MAY BECOME HOT
DURING USE. TO AVOID BURNS AND SCALDS
CHILDREN SHOULD BE KEPT AWAY.
n
WARNING: During use the appliance becomes hot.
Care should be taken to avoid touching heating
elements inside the ovens.
n
WARNING : Any spillages should be removed from
the hotplate lids before they are opened.
n
WARNING : This appliance is not intended to
be operated by means of an external timer not
approved by Stanley or a separate remote-control
system.
n
CAUTION: The cooking process has to be supervised.
A short term cooking process has to be supervised
continously.
n
WARNING: Danger of fire: Do not store items on the
cooking surfaces.
n
WARNING: Unattended cooking on a hob with fat or
oil can be dangerous and may result in fire. NEVER
try to extinguish a fire with water, but switch off the
appliance and then cover flame e.g. with a lid or fire
blanket.
n
IMPORTANT: Oil is a fire risk, NEVER leave pans
containing oil or fat unattended during the heating
or cooking period.
n
Never fill the pan more than one-third fill of fat or
oil.
n
Installation and maintenance must be performed by
a qualified installer or service agency.
n
WARNING! This appliance must be installed with
an appropriate device that will allow permanent
disconnection of the Live and Neutral conductors.
During Installation or disconnection prior to any
electrical work, the appliance must be permanently
disconnected from the Supply (Live) and Neutral
Conductors.
n
If a supply cord is damaged it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
n
DO NOT use a steam cleaner on your cooker.
n
To avoid overheating, DO NOT install the cooker
behind a decorative door.
n
For correct installation of the oven shelves, refer to
the user instructions.
n
DO NOT use abrasive pads, caustic cleaners, oven
cleaners or metal scrapers to clean the surfaces of
the enamel.
n
IMPORTANT: Stanley recommends Vitreous Enamel
Association approved cleaners for cleaning the
vitreous enamelled surfaces of this product.
n
DO NOT put oven doors or resting plates in a
dishwasher.
n
Children should be supervised to ensure that they
do not play with the appliance.
The appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
The appliance may contain some of the materials that are
indicated below. It is the Users/Installers responsibility to
ensure that the necessary personal protective clothing
is worn when handling where applicable, the pertinent
parts that contain any of the listed materials that could be
interpreted as being injurious to health and safety, see below
for information.
Glues and Sealants
Exercise caution - if they are still in liquid form use face mask
and disposable gloves.
Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre
May be harmful if inhaled. May be irritating to skin, eyes,
nose and throat. When handling avoid contact with skin or
eyes. Use disposable gloves, face-masks and eye protection.
After handling wash hands and other exposed parts. When
disposing of the product, reduce dust with water spray,
ensure that parts are securely wrapped.
