(2) Install Touchbar Switch Assembly and Route Wires
Mount Q Touchbar Switch with 2 screws (#8-32MS)
provided. Use plastic washers as spacers in-between the
assembly and bracket.
Route harness as shown, keeping it
clear of lower lip to avoid pinching.
Plastic
Washers
Q Touchbar Switch
Assembly
(wires not shown)
2 Screws
(#8-32MS)
Route harness through 2 holes at
either end of subplate as shown
and pull it snug.
2.4
Route harness up through lock side filler as
shown. Keep clear of moving parts and
cover.
Dress harness clear of lever arm
and lower lip to avoid pinching.
*Route harness through wire
hole in chassis. Keep clear
of moving parts.
2.1
2.3
2.5
2.6
2.2
2.6
VERTICAL
(2203, 2703, 2803)
or
RIM
(2103)
( * - If no hole in chassis available,
disassemble and drill a thru hole)
Q Option Upgrade Kit Installation Instructions
QSRK5267 / QSVK5268 Conversion Kits Page 2 of 3
B
12/4/2008
05269-11-000
REV
DATE
DRWG
Position harness in center and tape
down underneath subplate.
(RIM)
(VERTICAL)
.925”
#7 Drill (ǿ.201”)
for RHRB device
#7 Drill (
ǿ.201”)
for LHRB device
Lower Lip
Lever Arm
Note: ELR assembly is shown as example only.
Mount and adjust Bolt & Nut appropriately
for switch activation.
Route harness through
switch bracket.
