Cut Along the
Dotted
Line
Model SCSS-700
Basic Operating Instructions
These Instructions must be framed and displayed next to the SCSS-700 panel in
accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems. Test
the system in accordance to NFPA 72.
Operation
Task to Perform
Silence Alarms and
Troubles
Press
. Silence LED will light.
Reset Alarms
Press .
Acknowledge Alarms and
Troubles
Press
. When the Alarm or Trouble is acknowledged an
A
will appear in the
annunciator display as shown Below.
View Alarms,
Supervisories, and Troubles
For each type of condition press the
or
button associated for Alarms,
Supervisories, or Troubles.
Normal Standby
Green LED on ““Stanley SCSS-700 All Systems Normal”
Conduct a Fire Drill
Hold the
button enter a code if prompted or
1. Press
to access Main Menu.
2. Then press
to select System Tests.
3. Enter code if prompted, then press
to select Fire Drill.
4. Press
to start the fire drill.
5. Press
to end the fire drill.
View a Point’s Status
1. Press
to access Main Menu, then rotate the key or enter a code if prompted.
2. Then press
to select Point Functions.
3. Enter code if prompted, then press
to select Point Status.
4. Select the module the device is located on by using the
or
. Then press
.
5. Enter the point number.
Check Detector Sensitivity
1. Follow steps 1 through 5 for viewing a point status.
2. Press
to view detector sensitivity.
Set Time and Date
1. Press
to access Main Menu.
2. Then press
to select Set Time & Date. Enter a code if prompted
3. Make changes in the fields on the screen as necessary.
4. Press
if you wish to keep the changes.
5. Press
to set the entered time and date.
Enable / Disable a Point
1. Press
to access Main Menu, then rotate the key or enter a code if prompted.
2. Then press
to select Point Functions.
3. Enter code if prompted, then press
to select Disable / Enable Pt.
4. Select the module the point is located on by using the
or
. Then press
.
5. Enter the point number.
View Event History
1. Press
to access Main Menu, then rotate the key or enter a code if prompted.
2. Press
to select Event History.
3. Press the
or
to view events in the history buffer.
For Service call:
P/N 53723 Rev A
1
1
2
2
4
2
1
3
Acknowledge
Mark
Summary of Contents for SCSS-700
