LIGHTING THE STOVE
1.
Open the fire door and open the primary air inlet by pushing the primary air control lever to the right.
2.
Open the secondary air inlet by pushing the secondary air control lever to the left.
3.
Cover the grate with crumpled pieces of paper and lay 10-12 pieces of kindling on top of the paper
towards the back of the firebox.
4.
lgnite and close the fire door.
5.
When the kindling is well alight open the fire door and add more kindling of a larger size
to sustain the fire. Close the fire door.
6.
When a hot fire bed is established add the normal fuel.
7.
When well lighted, adjust the air controls as required depending on the fuel type being used & the heat
output required (see Table). Both controls should be adjusted in conjunction with each other to
get the appropriate burn rate with exact settings on each control depending on the draught conditions
of the chimney to which the unit is connected.
8.
If there is insufficient burning material in the firebed to light a new fuel charge, excessive smoke emis-
sion can occur. Refuelling must be carried out onto a sufficient quantity of glowing embers and ash that
the new fuel charge will ignite in a reasonable period. If there are too few embers in the fire bed, add
suitable kindling to prevent excessive smoke.
9.
The maximum amount of fuel specified in this manual should not be exceeded, overloading can cause
excess smoke.
INSTALLING SOLID FUEL KIT - 500 MODEL
IF OPTING TO BURN SOLID FUEL, A SOLID FUEL
KIT MUST BE INSTALLED.
1.
Open the firedoor and remove the ashpan.
2.
Lift out the grate by pushing it upwards
through the ash compartment.
3.
Remove the base bricks (see Fig. 17).
20
Fig.17
4.
Refit the grate.
5.
Fit the two refractory bricks as shown in fig.
19.
Fig.19
INSTALLING SOLID FUEL KIT - 900 MODEL
IF OPTING TO BURN SOLID FUEL, A SOLID FUEL
KIT MUST BE INSTALLED.
1.
Open the firedoor and remove the ashpan.
2.
Lift out the grate by pushing upwards
through the ash compartment.
3.
Remove the two floor bricks.
4.
Lay the two refractory bricks into the
firebox as shown in fig. 20.
5.
Refit the grate.
Fig.20
Fig.18
Base Bricks
Refractory Bricks
Summary of Contents for Solis Inset 500
Page 26: ...26 NOTES ...
Page 27: ...27 NOTES ...
