12 - ENG
SERVICE
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website at
www.stanleytools.com. You can also order parts from your nearest STANLEY Factory Service Center
or STANLEY Authorized Warranty Service Center. Or, you can call our Customer Care Center at
1-800-262-2161.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about
STANLEY, its factory service centers or authorized warranty service centers, visit our website at
www.stanleytools.com or call our Customer Care Center at 1-800-262-2161. All repairs made by our
service centers are fully guaranteed against defective material and workmanship. We cannot guarantee
repairs made or attempted by others.
You can also write to us for information at STANLEY, 4825 Highway 45 North, Jackson, Tennessee 38305
-Attention: Product Service. Be sure to include all of the information shown on the nameplate of your tool
(model number, type, serial number, etc.).
ACCESSORIES
Since accessories, other than those offered by STANLEY, have not been tested with
this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only
STANLEY recommended accessories should be used with this product.
A complete line of accessories is available from your STANLEY Factory Service Center or a STANLEY
Authorized Warranty Service Center. Please visit our Web Site www.stanleytools.com for a catalog or for
the name of your nearest supplier.
TROUBLESHOOTING
Risk of Unsafe Operation. Unit cycles automatically when power is on. When
servicing, you may be exposed to voltage sources, compressed air, or moving parts. Before
servicing unit unplug or disconnect electrical supply to the air compressor, bleed tank of
pressure, and allow the air compressor to cool.
PROBLEM
CAUSE
CORRECTION
Excessive tank pressure
- safety valve pops off.
Pressure switch does not shut
off motor when compressor
reaches "cut-out" pressure.
Move On/Off switch to the "Off"
position, if the outfit does not shut off
contact a Trained Service Technician.
Pressure switch "cut-
out" too high.
Contact a Trained Service Technician.
Air leaks at fittings.
Tube fittings are not
tight enough.
Tighten fittings where air can be heard
escaping. Check fittings with soapy
water solution.
Do Not Overtighten.
Air leaks in air tank
or at air tank welds.
Defective air tank.
Air tank must be replaced.
Do not repair the leak.
Risk bursting. Do
not drill into, weld or otherwise
modify air tank or it will weaken.
The tank can rupture or explode.
Air leaks between
head and valve plate.
Leaking seal.
Contact a Trained Service Technician.
Summary of Contents for STFP00020
Page 43: ...43...
