11
4. Press throttle interlock and throttle trigger.
1
2
5. Pull the recoil starter to start engine and the move
choke lever to “WARM START” position. Now, your
machine is under idle speed condition.
6. Let the machine run in idle speed for 10-15s to warm
up.
7. Depress throttle trigger to get full engine speed for
operation.
Start warm engine
1. Set ignition switch to “I” position.
2. Move choke lever to “WARM START” position, do not
depress primer bulb.
3. Press throttle interlock and throttle trigger.
4. Pull the recoil starter to start engine. Now, your
machine is under idlespeed condition.
5. Depress throttle trigger to get full engine speed for
operation.
STOP ENGINE
WARNING!
The cutting device will continue to
rotate for some time even after the engine has
been switched off! Wait until it comes to a complete
stop before you place down the machine!
1. Release throttle interlock and throttle trigger to return
to idle before shutting off engine
2. Set ignition switch to “STOP” position to shut off
engine.
ADJUST CUTTING ANGLE
1. The angle of gear head can be adjusted in 3 positions
according to the performed work.
2. To adjust, depress the lock pin and rotate the lower
shaft either to the right or left side until the pin locks in
position.
WARNING!
Never operate the machine if the
pin is not locked properly!
TRIMMING
Trimmer
1. Use the trimmer head and trimming guard to cut small
weeds, grass or similar soft vegetation.
2. Hold the machine with sufficient distance to your
body.
3. Pay attention to your posture. Stand upright, do not
lean forward.
4. Hold the trimmer head just above the ground at an
angle of about 30°.
G
B
