Stanley Supreme Deluxe 900, User Manual

21

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

130 mm

Positioning the Cooker

Fig. 7.1

 and 

Fig. 7.2 

show the minimum recommended 

distance from the cooker to nearby surfaces.
The cooker should not be placed on a base.
The hotplate surround should be level with, or above, 

any adjacent work surface. A gap of 75 mm should be left 

between each side of the cooker 

ABOVE

 the hotplate level 

and any adjacent vertical surface.
For non-combustible surfaces (such as unpainted metal or 

ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of 

the hob and a horizontal combustible surface.

*Any cookerhood should be installed in accordance with the 

hood manufacturer’s instructions.
**Any splashback must be fitted in accordance with the 

manufacturers instructions. Allowance should be made for the 

additional height of the flue trim, which is fitted to the cooker 

hob. 

Surfaces of furniture and walls at the sides and rear of the 

appliance should be heat, splash and steam resistant. Certain 

types of vinyl or laminate kitchen furniture are particularly 

prone to heat damage and discolouration. We cannot accept 

responsibility for damage caused by normal use of the 

cooker to any material that de-laminates or discolours at 

temperatures less than 65 °C above room temperature.
We recommend a gap of 910 mm between units to allow 

for moving the cooker. Do not box the cooker in – it must 

be possible to move the cooker in and out for cleaning and 

servicing.
If the cooker is near a corner of the kitchen, a clearance of 

130 mm is required to allow the oven doors to open 

(Fig. 7.3)

. 

The actual opening of the doors is slightly less, but this allows 

for some protection of your hand as you open the door.

Moving the Cooker

n

n

On no account try and move the cooker while it is 

plugged into the electricity supply.

n

n

The cooker is very heavy, so take great care.

We recommend that two people manoeuvre the cooker. 

Make sure that the floor covering is firmly fixed, or removed, 

to prevent it being disturbed when moving the cooker 

around.
To help you, there are two levelling rollers at the back, and 

two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt 

the cooker backwards and remove the front half of the 

polystyrene base 

(Fig. 7.4)

. 

Repeat from the back and remove the rear half of the 

polystyrene base.

410 mm min

5mm

5mm

**

900mm min*

Fig. 7.3 

Fig. 7.4 

ArtNo.245-0031 - 110 IN G5 - Masterchef -  Cooker clearance 2

75 mm

min

75 mm

min

650 mm

min

905 mm

min

930 mm

max

Fig. 7.1 

Fig. 7.2