Stanley Supreme Deluxe 900, User Manual

22

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

ArtNo.070-0014 - Stability bracket - Wall fitting

Cooker

Stability bracket

Floor

3 mm min

Typical floor mounting

Cooker

Outer stability

bracket

Floor

Wall

3 mm min

Typical wall mounting

Stability chain

ArtNo.010-0004 Moving the cooker

Fig. 7.6 

Fig. 7.7 

Fig. 7.8 

Fig. 7.5 

Fig. 7.9 

Lowering the Two Rear Rollers

To adjust the height of the rear of the cooker, first fit a 13 mm 

spanner or socket wrench onto the hexagonal adjusting 

nut 

(Fig. 7.5)

. Rotate the nut – clockwise to raise – counter-

clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS. 

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the 

oven doors so that you can get a good grip on the bottom of 

the fascia panel as you move the oven 

(Fig. 7.6)

.

Carefully push the cooker backwards off the base tray. 

Remove the base tray.
Position the cooker close to its final position, leaving just 

enough space to get behind it.

n

n

DO NOT use the door handles or control knobs to 

manoeuvre the cooker.

Fitting the Stability Bracket or Chain

Unless otherwise stated, a cooker using a flexible gas 

connector must be secured with a suitable stability device.
Suitable stability devices are shown in 

Fig. 7.7

, 

Fig. 7.8

 and 

Fig. 7.9

.

If you are using a stability chain 

(Fig. 7.7)

 then the chain 

should be kept as short as is practicable and fixed firmly to 

the rear of the cooker.
If you are using a stability bracket (

Fig. 7.8

 and 

Fig. 7.9

), then 

adjust the bracket to give the smallest practicable clearance 

between the bracket and the engagement slot in the rear of 

the cooker.
Fit the bracket so that it engages as far as possible over the 

chassis of the cooker.

Repositioning the Cooker Following 

Connection

If you need to move the cooker once it has been connected 

then you need to unplug it and, having gripped under the 

fascia panel and lifted the front of the cooker slightly  

(Fig. 7.6)

, you need to check behind the cooker to make sure 

that the gas hose is not caught.
As you progress, make sure that both the electricity cable and 

gas hose always have sufficient slack to allow the cooker to 

move.

With a stability chain fitted, release it as you ease the cooker out. 

Do not forget to refit it when you replace the cooker.

When you replace the cooker, again check behind to make 

sure that the electricity cable and gas hose are not caught or 

trapped.