Scanner driver detail
Connect the power lead to the power supply output.
Orange is +24V Black is 0V and Yellow is –24V.
The power lead is supplied at 50cm but can be cut to
length as required. Once cut, the fork terminals should be
fixed by crimping or soldering onto the stripped wire ends
before connection is made to the power supply.
Make sure to connect the other end of the power lead to
the correct connection on the input board, if power is
connected to one of the signal inputs damage to the driver
card will occur.
Before applying mains power check the voltage selection
switch (see right) on the power supply is set to match your
local supply voltage. The switch is set to 240v when moved
to the right and to 110v when moved to the left.