8839615
V 1.4
Visit
for more information
11
Step
Description
22.
Install the rearview mirrors. Locate the rearview mirrors, and remove the M10 nuts (Fig. 17). With the
flat washer on top side of the wheel well, place the driver’s side mirror (Fig. 17, Bottom) into the hole in
the wheel well on the drivers side. Be sure that the bolt on the mirror passes through the Mirror Bracket
underneath, if necessary, align the bracket with the hole. Use the M10 nut to hand tighten the mirror in
place. While holding it in the correct position (Fig 18), and using a 14mm socket and socket wrench,
tighten the M10 nut. Repeat this step for the passenger side mirror (Fig. 18, Top).
23.
Attach the seat cushion and handrails to the vehicle body. Remove the five M8 x 50mm shoulder bolts,
self locking nuts, and three flat washers (Fig. 19) where the seat is to be installed. Place the seat
cushion onto the body and install the three M8 x 50mm shoulder bolts at the back of the seat as shown
in circled areas of Fig. 20 with the flat washer and bolt on the top, nut underneath, DO NOT TIGHTEN.
Next, use the remaining two M8 x 50mm shoulder bolts and nuts (Fig. 19, Right) with the nut
UNPACKING AND ASSEMBLY
underneath, DO NOT TIGHTEN. Next, secure the rear of
the armrest with the uppermost screw on the seat back
using a 4 mm hex key (Fig. 22, circled). Once the rear of
the armrest is tightened, use a 12mm socket, socket
driver, and 12mm box end wrench to secure the front of
the handrails (Fig. 21) and the rear of the seat cushion
as shown in circled areas of Fig. 21.
24.
Install the spare tire bracket and spare tire. Locate the
spare tire bracket (Fig. 23), the two M8 x 65mm shoulder
bolts and self locking nuts, the one M6 x 30mm bolt and
nut, and the hollow 16mm x 16mm x 8.5mm
stanchion/spacer. Place the bracket on the passenger
side rear of the vehicle body (Fig.24), align the holes and
insert the two M8 x 65mm shoulder bolts and hand
tighten the self locking nuts. Put the stanchion/spacer
between the frame and the body on the bottom of the
bracket, then insert the M6 x 30mm bolt through the
bracket, stanchion/spacer and body. Tighten the M8 x
65mm bolt and nuts using a 12mm socket and socket
wrench and a 12mm box end wrench, then tighten the
M6 x 30mm bolt and nut using a 8mm socket and socket
wrench and 8mm box end wrench.
Fig. 19
Fig. 20
Fig. 21
Fig. 22
