CAUTION
This equipment is designed and sold for commercial use only by personnel trained and experienced
in its operation and is not sold for consumer use in and around the home nor for use directly by
the general public in food service locations. For equipment to be used by the general public,
please contact the factory.
INSTALLATION
This grill is equipped for the voltage shown on the nameplate. It will operate on alternating
current only, however, the specified voltage must be applied.
WARNING
DO NOT CONNECT TO DIRECT CURRENT (DC).
CONNECTION LOAD:
MODEL SERIES
WATTAGE
PLUG TYPE
75SCRHB7, 40V
500
NEMA 6-5P
75SZRHB7, 0v
00
IEC, 0 6 AMP
75SZRHB7, 40V
500
NEMA 6-5P
The grill should be connected to a wall type receptacle, a direct line, or an individual branch
circuit. An individual branch circuit is preferred. Do not connect to an overloaded circuit.
The unit should be level when installed. Adjustable 4-inch legs are standard on the 75 Series
and available for all other models. Do not install -inch legs on the 75 Series Roller Grills. This
will result in an unsafe condition.
GENERAL OPERATING PROCEDURES
The main switch located on the control panel controls all the power to the unit. With the main
switch on, the rollers will turn and heat will be supplied to the bun box, but no heat will be
supplied to the rollers unless the heat controls are turned on. The heat supplied to the bun box
is not adjustable. Model
75SZRHB7
is equipped with a bun box cover, designed to prevent the
contents fresher longer.
For flexibility the heating section of the grill is divided into two individually controlled heat
sections. The right control regulates the heat to the rear section and the left control regulates
the heat to the front section. The switch is lighted to indicate when the unit is turned on.
A signal light is provided above each heat control and indicates when the heated section is on.
An additional light is provided on the end housing of the unit. This light indicates the position
of the main power switch.
CAUTION
INTERNAL DRAWER COMPONENTS & DRAWER CAVITY ARE HEATED. ALLOW
THE DRAWER & CAVITY TO COOL DOWN BEFORE SERVICING.
To remove the bun drawer, grab the drawer by both sides and pull it out all the way. Lift the
front to unhook the drawer slide from rear drawer roller. Pull the drawer the remainder of the
way out. Use caution when handling the drawer, let it cool down to room temperature prior to
cleaning or removing. Use caution not to drop the drawer when reaching the end of the drawer
slide travel. To reinsert the drawer, first hook the drawer slide over the front roller then the back
roller. Do not operate the grill without the drip tray in place.
CAUTION
USE ONLY PLASTIC OR COATED UTENSILS FOR HANDLING THE FOOD PRODUCT.
METAL COULD SCRATCH THE ROLLER COATING AND AFFECT THE CLEANABILITY
OF THE ROLLERS.
