5
Installing the platen knob
The platen knob is packed into a recess in the
packaging material.
❏
Install the knob on the shaft located inside the
large hole on the right side of the printer. Make
sure that the two splines of the platen shaft inside
the printer fit into the slots inside the knob’s
spindle. Press the knob carefully but firmly into
place as far as it will go.
Opening the front cover
❏
Lift up on the front cover while pressing in gently
on its sides.
❏
To close the front cover, simply lower it back into
place.
Caution!
The tear assist edge is rather sharp. Take care to
avoid injuring your hands.
Note:
You can completely remove the front cover from the
printer or you can stand it up without removing it.
You should normally leave the front cover closed,
because it protects against objects getting into the
printer, and it cuts down on printer nois
e
.
Platen knob
Molette du cylindre
Walzendrehknopf
Manopola del rullo
Front cover
Capot avant
Frontabdeckung
Coperchio anteriore
Tear assist edge
Barre de découpe
Papierabrißkante
Listello di separazione
