6
PT-10Y Push Tractor Unit
Important!
Make sure that the paper is aligned properly on the tractor pins. Otherwise, it
may tear or jam.
❏
Close the tractor covers. At this point you can make final adjustments to the
paper position by releasing the gray levers and moving the tractors. After
making these adjustments, be sure that you re-lock the tractors by pushing
the gray levers back into their original positions.
❏
Carefully lower the automatic sheet feeder into the printer, making sure that
the two round tabs on either end of it enter into the slots inside the printer.
You should have the automatic sheet feeder angled towards the front of the
printer (at about the same angle that it was when you pulled the feeder
forward while detaching it).
❏
Lower the automatic sheet feeder all the way down. When you do, it should
naturally slip into place, with the part that holds the paper angled slightly
towards the back of the printer.
❏
Close the front cover of the printer.
Important!
If you leave the paper support installed on the printer while there is no paper
in the automatic sheet feeder, it will catch on the fanfold paper that is fed from
the printer and cause paper jams. Detach the paper support from the printer
when there is no paper in the automatic sheet feeder.
