Software Manual
97
Caution When using the on demand function, check the following information.
When the on demand function is enabled, the time that the confirmation dialog box
appears may vary according to the printing channel that is used.
The time that the confirmation dialog box appears for each channel is as follows:
Printer Driver
Immediately after a cut
command is sent
OPOS
JavaPOS
WritePrinter API
Immediately after a cut
command is sent (Refer to
following *1 *2)
Virtual Serial Port
Virtual TCP/IC Port
Immediately after a cut
command is sent (Refer to
following *3)
*1)
Even if the write data contains several cut commands, the last cut command is
recognized as the trigger and the confirmation dialog box appears. However, when
multiple receipts are sent in a single batch through a virtual serial port, the data will
be divided automatically for processing if it exceeds the buffer capacity. In this case,
the cut command just before the buffer becomes full is the trigger. When using a
virtual serial port, it is recommended to send the data one receipt (data + cut
command) at a time.
*2)
Even if the write data is sent one line at a time, the confirmation dialog box will not
appear and the data will not be printed until a cut command is received.
*3)
Send print data on a page basis (data + Cut command).
Also, select “Yes” or “No” in the confirmation dialog box, and send the next print
data.
Note: When switching from the TSP100IIU to the TSP100U, the ECO settings may not
appear in the TSP100U configuration utility. If the ECO settings were used for the
TSP100 ECO, perform the following procedure to reset all of the settings to the
default settings, and then use the TSP100U.
1 Insert the CD-ROM into your computer's CD-ROM drive.
2 Start the configuration utility.
3 Import the following files by selecting File
→ Import.
Star line mode :
CD-drive:\Windows\ConfigurationSettingFiles\TSP100ECO\default.config.xml
ESC/POS mode :
CD-drive:\Windows\ConfigurationSettingFiles\TSP100ECO\escpos.xml
