Software Manual
86
■ Print Width
The print width should be set according to the size of paper used. The default (recommended
print width) is 72 mm.The standard default print width is 72 mm, which provides 4-mm margins
on both sides of 80-mm paper. The 51-mm print width setting is appropriate if you are using the
optional 58-mm paper supported by the TSP100 futurePRNT.
Notes:The print width is automatically changed to fit the paper width specified at addition
of the OPOS POS printer.
After changed automatically, do not adjust the print width manually.
■ Automatic Retry
If a printing error occurs while "Automatic Retry" is set to "Enable", the sent data is resent from
the beginning.
Retry processing is repeated up to five times.
The default is "Enable" for TSP100U/PU/LAN/ECO, and "Disabled" for TSP100GT.
Note:
1 If "Automatic Retry" is set to "Disabled", the ETB command is enabled in the
application side. However, check that the ETB is returned for one job before sending
the next print data.
If print data is sent simultaneously from multiple PCs, the ETB
will not be guaranteed.
2 In the ESC/POS mode, the ETB command is not available even if "Automatic Retry"
is disabled.
3 The automatic retry function is not available for OPOS, JavaPOS, virtual serial port,
and virtual TCP/IP port.
■ Characters/Line (font A) <ESC/POS mode only>
42 char. (default)
: The standard for ESC/POS mode.
48 char.
: The standard for Star Line mode.
