Software Manual
51
3.4. Control Font Usage
The Control device font is used to provide for control within the span of a single document.
This font is not used for character printing.
3.4.1. Control Font list
The following table is the list of the supported control device fonts.
Character
Function
A
Open cash drawer 1 for 50 mSec.
B
Open cash drawer 1 for 100 mSec.
C
Open cash drawer 1 for 150 mSec.
D
Open cash drawer 1 for 200 mSec.
E
Open cash drawer 1 for 250 mSec.
d
Open cash drawer 2 for 200 mSec.
6
LF
7
CR
F
Full Cut
P
Partial Cut
a
Set Left Alignment
b
Set Center Alignment
c
Set Right Alignment
e
Set 3mm line feed spacing (1/8 inch)
f
Set 4mm line feed spacing (1/6 inch)
g
Select USA international character set
h
Select France international character set
i
Select Germany international character set
j
Select England international character set
k
Select Denmark I international character set
l
Select Sweden international character set
m
Select Italy international character set
n
Select Spain I international character set
o
Select Japan international character set
p
Select Norway international character set
