Software Manual
84
■ Character Encoding
The default character encoding is "Single Byte Characters".
Selects the character encoding used by the printer. You can select either single-byte encoding
(common for all non-Asian languages) or any of the four available double-byte encodings (for the
corresponding Asian languages).
■ Font Type <ESC/POS mode only>
Standard
: (the default): Selects the standard font.
Large
: Selects a rounder, bulkier-looking font.
If "Large" is specified for "Font type", a larger text is created based on a font
design, and it looks a little tight because the character space is the same as for
the standard font type
.
■ Character space (Right) <ESC/POS mode only>
0
(the default) to
3
dots
Use this feature to add extra space (in dot units) to the right of each character. Extra spacing may
improve appearance when you are using the Large font type.
4.3.2. Default Print Settings
■ Line Spacing
The default line spacing is "4 mm".
If the spacing is set to 4 mm (the initial setting), the printer will add a 1-mm line space between each 3-
