– 29 –
(5) Press and hold the FEED button, and turn
ON the power switch of the printer. The
two lamps will flash on the control panel to
indicate that the sensor adjustment mode
has been activated. After the lamps flash,
release your finger from the button.
(6) If the two lamps remain ON after flashing, it means that the sensor is adjusted properly and
does not require further adjustment. Proceed to (8).
(7) If both the ERROR and POWER lamps are OFF, turn and adjust the VR2 knob to a position
in which both lamps are ON. If the adjustment has not been successful, have the printer
repaired.
(8) Turn OFF the power switch and set the dip switch SW1-4 to ON.
(9) Return the dip switches SW1-5, SW1-6, and SW1-7 to their original settings.
5-4-3. Adjusting the label roll paper peeler sensor
(1) Remove the roll paper from the printer.
Verify that there is no paper in the vicinity
of the peeler sensor, and close the printer
cover.
(2) Turn OFF the power to the printer. (For
safety, unplug the power cable from the
outlet.)
(3) Undo the screw and remove the dip switch
cover from the bottom of the printer.
(4) To activate the sensor adjustment mode,
use a pointed object to set the dip switches
as follows:
DSW 1-4 = OFF, DSW 1-5 = OFF,
DSW 1-6 = ON, DSW 1-7 = ON
(5) Turn ON the power switch of the printer.
The two lamps will flash on the control
panel to indicate that the sensor adjust-
ment mode has been activated.
1
2
3
4
5
6
7
8
1
2
3
4
VR1
OFF
ON
