– 3 –
Choosing a place for the printer
Before actually unpacking the printer, you should take a few minutes to think about where
you plan to use it. Remember the following points when doing this.
✓
Choose a firm, level surface where the printer will not be exposed to vibration.
✓
The power outlet you plan to connect to for power should be nearby and unobstructed.
✓
Make sure that the printer is close enough to your host computer for you to connect the
two.
✓
Make sure that the printer is not exposed to direct sunlight.
✓
Make sure that the printer is well away from heaters and other sources of extreme heat.
✓
Make sure that the surrounding area is clean, dry, and free of dust.
✓
Make sure that the printer is connected to a reliable power outlet. It should not be on the
same electric circuit as copiers, refrigerators, or other appliances that cause power
spikes.
✓
Make sure that the room where you are using the printer is not too humid.
WARNING
✓
Shut down your equipment immediately if it produces smoke, a strange odor, or unusual
noise. Immediately unplug the equipment and contact your dealer for advice.
✓
Never attempt to repair this product yourself. Improper repair work can be dangerous.
✓
Never disassemble or modify this product. Tampering with this product may result in
injury, fire, or electric shock.
CAUTION
✓
When using a thermal label roll paper, do not install the tension bar, two tension folders,
and two springs; otherwise, a paper jam could result.
